Cisco ios xe vs ios commands1/8/2023 Need to use an available IP address besides the interface address in a pool and that works as noted in the below example. The Match-in-VRF Support for NAT feature is not supported on interface overload configuration. Restrictions for Match-in-VRF Support for NAT Ip nat inside source list nat-acl interface GigabitEthernet0/0/0 vrf INET overload NAT NVI is not supported in "NAT on-a-stick" scenario and it was designed for traffic from one vrf to another and not for routing between subnets in the global routing table.įor additional information about this feature please refer: This is supported through a feature called NVI (NAT Virtual Interface). Permit ip 172.16.1.0 0.0.0.255 any NAT between two different VRFs Ip nat inside source list nat-acl interface FastEthernet4 vrf INET match-in-vrf overload ![]() ![]() ![]() Ip nat inside source list nat-acl interface GigabitEthernet0/0/2 overload ![]() Supports interface overloading interface GigabitEthernet0/0/3 Ip nat inside source list nat-acl interface FastEthernet4 vrf INET overload
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |